DIY

Stir It Up with Photo Strips!

Get creative with your cocktails by creating customized stir sticks for your party peeps!

MDSQ

SNAP "SHOT"

  • Download the MADESQUARE app and order your photo strips (NOW!)
  • Lightly spread the glue on the back of your photo strip and gently press it to the foam board
  • Cut around the edge of each photo, they should measure 1.5 x 1.5 inches when finished
  • Wrap your washi tape around the outer edge of the foam board
  • Press your wooden skewers into the bottom edge
  • Once you know the size of your cocktail glass — trim them to fit
MDSQ

FLAGS — ATTENTION!

  • Place washi tape along the top edge of a square kraft note card
  • Cut along the bottom edge of the tape
  • Fold each flag in half
  • Run a glue stick from one end of the flag to the middle, place the skewers in the center and close the flag.
  • Cut a triangle into each flag end
  • Write or stamp your guests' names, cheers, or other party phrases on each flag
  • Once you know the size of your cocktail glass — trim them to fit
MDSQ

SPARKLE SPIRIT

  • Cut a one to three inch piece of tinsel
  • Apply a small dot of hot glue on the end of each wooden skewer
  • Wrap the tinsel around it
  • Secure with an additional dot of glue
  • Once you know the size of your cocktail glass — trim them to fit